Keep in mind the size of the room in which you plan to install the water heater. Apparatus sixty liters in volume and more cumbersome and not any flat wall stand barrel, the height of one meter in diameter and 50-60 cm depending on the type of heater and the desired temperature, the required energy output ranges from 400-500 in storage heaters (if you want to heat the water to 40-50 degrees) to 6 – 7 kW at flow heaters. Electricity in homes in most cases, this load can not stand, so you should just get ready to either replace the wiring in the apartment, or a separate cable for wiring exclusively for the water heater. Storage water heaters consume energy not only during the heating of water, and with the support of its temperature, which is why electricity bills you probably unpleasantly surprised. In Unlike a microwave oven, which consumes more energy, but not long term, water heater uses electricity big time and the ideal choice for power and volume of the tank will allow you to significantly save money without sacrificing comfort when using hot water. More info: Tallulah & Bird Interior Design. When you purchase a water heater should turn its attention to the material, of which the tank itself and for shielding.
Often the inner tank is made of corrosion of steel, and external – of enameled steel. This material is resistant to high temperature, non-toxic and provides thermal insulation. We need to think about water filters, out that access into the interior of the tank there, rinse it possible either. The best way to not pollute the tank – clean water. Connecting and installing water heaters – a process crucial and complex. Trust should be exclusively specialists. Not only because it skillfully to make the wiring pipes many can not afford, but also because the quality of such a facility in a professional will be much higher, and again, you will not have to blush in front of neighbors over a puddle, which they are even made to your house boiler.